Manually bump testing and calibrating gas detectors is a time-consuming burden for many organizations. The MX•Cal Calibration Station simplifies these tasks, allowing users to initiate them with the push of a button.

The MX•Cal is easy to transport with no PC required. When used with a PC, the MX•Cal automatically downloads calibration and bump test reports via a standard USB connection (USB 2.0 preferred). Users can access alarm event data to keep track of gas exposure or to monitor high-risk areas. This PC connection also makes it easy to configure the MX4’s preferences.

An optional serial data dot matrix printer automatically prints calibration and bump test reports. This proves regulatory compliance with records of instrument serial numbers, pass/fail indications, bump test readings and full span readings for the MX4.

Gas Detectors Supported:
MX4 iQuad™ (all configurations)

Dimensions:
140 mm x 270 mm x 150 mm (5.51" x 10.63" x 5.91")

Gas Inlets:
One fresh air, one gas cylinder

Pump Flow Rate:
500 ml/minute

INPUT:
Universal AC power supply; 110 / 240 VAC, 50/60 Hz 

Communication:
On-board LEDs give status indication (pass, fail, li-ion battery charging). Multilingual LCD display shows status and set-up menus. Real-time readings on the MX4 display during calibration.

Internal Memory:
Stores up to 150 bump test and calibration reports before overwrite. Reports contain serial number, time, date, sensor information, pass/fail, span values or bump values (for bump tests). Memory will retain information when power is off.